Flexible bituminous angle fillet documented in the historical Börner technical archive.
Flexible bituminous angle fillet
This material belongs to the bituminous roofing archive category. Its position and responsibility must remain clear when it is compared with primers, vapour-control layers, underlays, exposed membranes, drainage products or detailing components.
Essential technical data
- Product code
- TN618718
- Thickness
- Approximately 18 mm ±5%
- Mass
- Approximately 5.5 kg per roll
- Dimensions / packaging
- 6.25 m ±5% long; 46 mm ±5% wide
- Reinforcement
- Not applicable
- TDS revision
- 2019-01
- Source table page
- 1
Thermal conductivity and R-value are not declared in the reviewed TDS.
4 rolls per box; 24 boxes per pallet. Source describes cold application with local warming of the contact area. Density printed as approximately 1.3 g/m³ is retained only as an unresolved source unit, not a usable material property.
Four checks before this material enters a build-up.
- 01Confirm the exact function
Check that the product is being used for the technical role shown on this page rather than as a substitute for another layer.
- 02Assess the substrate and attachment
Confirm the support layer, surface condition, preparation and the approved method of bonding, fixing or application.
- 03Coordinate every interface
Review laps, seams, edges, outlets, penetrations, corners, terminations and compatible adjacent materials.
- 04Check current controlled information
Verify the current TDS, DoP, fire data, installation guidance, warranty route and project-specific requirements before use.
Archived technical data sheet
English · PDF · Revision 2019-01. Historical reference; check current controlled documents before specification.
PDF upload pending